Press and hold the Mode/Reset button for 3 seconds until the error disappears. If the error returns within 24 hours, call a technician. 10. Flue System Requirements The Lambert LX 24 FI is approved for concentric flue (60/100 mm) or twin pipe (80/80 mm) with adaptor.
Keep this article with your boiler’s official manual. For firmware-specific instructions or revised error codes, scan the QR code on the boiler’s side label or visit the Lambert support portal. lambert lx 24 fi instrukcia
Changing parameters incorrectly can cause unstable combustion, sooting, or overheating. Only qualified technicians should modify P01, P08, P10. 8. Maintenance Schedule (For Long Life) To keep the warranty valid and ensure safety, follow this schedule: Press and hold the Mode/Reset button for 3
This long-form article serves as a complete instruction manual (instrukcia) covering installation prerequisites, control panel operation, daily use, parameter settings, maintenance schedules, error codes, and safety precautions. Always refer to the official Lambert documentation supplied with your unit, as regional gas and water regulations may vary. | Parameter | Value | |-----------|-------| | Type | C13, C33, C53 (concentric flue) | | Max heat output (heating) | 24 kW | | Min heat output (heating) | 5.4 kW | | DHW output (max) | 24 kW | | Efficiency class (heating) | ★★★ (ErP) | | NOx class | Class 6 | | DHW flow rate (ΔT=30°C) | ~11.4 l/min | | Inlet gas pressure (G20) | 20 mbar | | Electrical supply | 230V ~ 50Hz | | Power consumption | ~110 W | | IP rating | IPX4D | | Expansion vessel capacity | 6 l (pre-charge 1 bar) | | Max heating pressure | 3 bar | | DHW range | 30–60°C | | Heating flow temp range | 20–85°C | Flue System Requirements The Lambert LX 24 FI
