If cleaning fails, the next step is . One should verify that the rotor’s hub is not cracked, that the O-ring (if present) is seated correctly, and that the locking nut or lid can be tightened without excessive force. In models with a spring-loaded sensor pin, manually pressing the pin with a non-metallic tool can confirm whether it moves freely.
Rotor dropping, overtightening, or cross-threading can deform the rotor’s bottom surface or push the sensor pin out of alignment. In some models (e.g., Eppendorf 5702), a spring-loaded contact pin in the motor shaft must physically touch a conductive pad on the rotor. If that pin is stuck in a depressed position due to dried media or mechanical wear, the centrifuge behaves as if no rotor is present.
The rotor’s underside and the motor cone are exposed to chemical spills, saline residues, and condensation from refrigerated runs. Over time, a thin film of dried salt, protein, or metal oxide can insulate the magnetic or contact-based sensors. Even a tiny speck of rust or a layer of grease can prevent the sensor from detecting the rotor’s presence. This is especially prevalent in older Eppendorf 5424/5430 series or refrigerated 5804 models where the sensor is a small reed switch or hall probe.
If the control board receives no signal or an invalid signal, it defaults to the safest possible state: complete refusal to spin, accompanied by the “No Rotor” error. The error rarely means “no rotor.” Instead, it signals a breakdown in communication between the rotor and the centrifuge’s logic. The causes fall into three categories.
Online a mais de 10 anos, o Meuhentai.com trás para você quadrinhos exclusivos e de qualidade, com o melhor conteúdo de toda internet, para que você tenha acesso a aventuras eróticas e quadrinhos sem censura sem pagar! Fique a vontade para navegar com segurança em nosso site e ter acesso a HQs maravilhosas, coloridas e selecionadas para você!