Plc Resueltos - Ejercicios De

Here’s a structured list of (from basic to intermediate) with explanations, logic, and pseudo-code. These are typical for Siemens S7-1200/1500 (TIA Portal) or Allen-Bradley (RSLogix 5000) but the logic applies to any brand. 🔹 Exercise 1 – Start/Stop with Latch (Motor Control) Statement: Control a motor with two pushbuttons: Start (NO) and Stop (NC). Add an overload relay (NC) as protection. Use a latching relay.

---[Start]---[Stop]---(TON_1.IN) TON_1.PT := T#5s ---[TON_1.Q]---(Motor) TON_1 starts timing when Start is pressed. Q turns ON after 5s if Start remains pressed. 🔹 Exercise 4 – Counter (Count Products) Statement: A sensor (photocell) detects products on a conveyor. Count up to 100, then stop the conveyor and reset with a button. ejercicios de plc resueltos

IF Sensor_Rising_Edge AND (Count < 100) THEN Count := Count + 1; END_IF; IF Count >= 100 THEN Conveyor := FALSE; END_IF; Here’s a structured list of (from basic to

IF (X1 OR X2) AND NOT previous THEN Lamp := NOT Lamp; END_IF; previous := X1 OR X2; Use two Set/Reset coils with interlocking. 🔹 Exercise 3 – Timer (Delayed Start) Statement: When Start is pressed, after 5 seconds motor turns ON. When Stop is pressed, motor turns OFF immediately. Add an overload relay (NC) as protection