You cannot "wing it" on an MCX. You need the schematic logic provided by the manual. The biggest source of panic for new MCX owners is the Routing matrix .
The two mid-band EQs are semi-parametric (frequency sweepable), but the manual notes that at the extreme ends of the sweep, the Q (bandwidth) changes. At 200Hz, it acts as a wide shelf. At 1kHz, it's a tight notch. If you don't know this, you will chase feedback all night. Where to Find the Dynacord MCX 16.2 Manual Today Dynacord was bought by Electro-Voice (EV), which is now owned by Bosch. The official Dynacord website has scrubbed most legacy product support. Dynacord Mcx 16.2 Manual
On many consoles, muting a channel kills the Aux sends. On the MCX, it depends . The manual clarifies that Aux 1-4 are "post-mute" by default (if set to post-fader), but Aux 5-6 can be set to "pre-mute" via internal jumpers. This is crucial for monitor mixes. You want the vocalist's reverb to die when you mute the channel? Or keep ringing? The manual has the flowchart. You cannot "wing it" on an MCX
Furthermore, the manual dedicates three full pages to the . You can route Subgroups 1-2 directly to the Main L-R, or you can use them as an independent mix. If you lose your main left channel, the manual teaches you how to repurpose the subgroups as your new master section in an emergency. If you don't know this, you will chase feedback all night
https://genomealberta.ca/